load balancing using IGRP

Thread View: comp.dcom.sys.cisco

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Robert Craig Tue, 10 Apr 1990 06:59

#404

Author: Robert Craig
Date: Tue, 10 Apr 1990 06:59

25 lines
1265 bytes

We are trying to balance the load between two
sites, using 2 parallel 56kbps circuits.
We are using IGRP.
The second (new) line is barely used, the old one
just as congested as ever.
 
The problem as I see it is the ip route-cache.
(Note:  this is
not the routing database, but the cache which
says to get to network x send out interface
y--the contents of this cache are displayed using
the show ip route-cache command).
 
Route-caching may be disabled on an interface basis,
but this does not affect the contents of the cache.
 
Is there a way (undocumented,
as far as I can tell) to clear this cache, short of powering
off the router?
 
Robert Craig                          domain: robert@vm1.mcgill.ca
Network Analyst                       bitnet: robert@mcgill1
McGill University Computing Centre    Tel: (514) 398-3710 (office)
805 Sherbrooke St. W.                 FAX: (514) 398-6876
Montreal, Quebec H3A 2K6              CORISQ: (514) 398-RISQ

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads