TAPI Drivers for MegaHertz

Thread View: comp.dcom.telecom.tech

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by cccef.bgriffis Tue, 07 Nov 1995 00:10

#22

Author: cccef.bgriffis
Date: Tue, 07 Nov 1995 00:10

16 lines
1070 bytes

I am running Act! 2.06 with a laptop and a MegaHertz modem (X-Jack 
PCMCIA modem). I am attached to an AT&T G3i PBX and a 7406 set using 
a Konexx 111.

I would like to TAPI-enable the application without going to AT&T 
PassageWay Direct Connect (I use an AT&T switch in some offices, 
Northern Telecomm switches in others, and whatever is available at 
hotels.).

Are TAPI drivers available for the MegaHertz modem? Is there a BBS I 
can dial up and get the drivers?

Any help would be appreciated!

Bruce Griffis		cccef.bgriffis@capital.ge.com

Re: TAPI Drivers for MegaHertz

#23

Author: J.R. Heisey
Date: Wed, 08 Nov 1995 04:14

19 lines
1457 bytes

Hi,

1) The TAPI software developers kit (SDK) for Windows 3.x comes with a 
AT command set service provider that should work with most modems. The 
TAPI SDK is available on Microsoft's ftp server. ftp.microsoft.com

1a) Since you are asking about ACT! and TAPI can I assume you are using 
ACT! Phone Link add-on application. This came with the AT command set 
service provider. It should have been installed into you windows/system 
directory when you install ACT! Phone Link. Go to the Control Panel 
Telephony  applet and it should appear as ATSP

2) For Windows95 you just need to go to the control panel and click the 
modem icon to configure your modem. TAPI under Windows95 is always setup 
to use the Unimodem driver.

Good luck
J.R. Heisey
Symantec Corp.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads