🚀 go-pugleaf

I am writing a report on different approaches to generate code for a
DSP processor and would like to hear some opinions of the net-people
about this.

As far as I know most of the code for a DSP-processor is written in
assembler because either there is no suitable compiler available or
the compiled code is not good enough. Code generated by a C-compiler
for a commercial DSP-processor would be about 5 times as big as the
same algorithm manually coded in assembler.
On the other hand I read in an EDN issue (of 7 november 1991) that
some people do 90% of their code in C and 10% of the code in assembly
language (I think of this as an application of the 90/10 rule -- i.e.
that 90% of the execution time of a program is spent in 10% of the
code -- so that these 10% of code must be optimal).

- Which method do you use to write code ?
- Do you agree on the above ? (on the use and the quality of DSP compilers)
- What causes this factor of 5 on the code size ?
   e.g. -> the input language ? 
            - not enough parallelism in C (too difficult to extract the
              parallelism)?
            - too many possible constructs in C ? (a subset of C is better)
            - non-procedural languages as e.g. Silage are better ?
        -> no global ordering and scheduling of the generated code ?
        -> no possibility of using all the provided tricks for the DSP
           processors ?
            - no or not enough use of the low-overhead-loop facility of a
              processor as the "DO" for Motorola and the "RPT" for Texas
              Instruments processors ?
            - no use of special addressing ? (e.g. in circular buffers)
            - no use of special block data moves ?
            ...
         ...

I also know of two code generation approaches that would generate more
optimal code : - The GABRIEL (PTOLEMY) system of prof. Lee at Berkeley
                 (mainly targeted towards the Motorola 56k)
               - The code generator for Texas Instruments' TMS320C30 in the
                 DSP-station of EDC (in Belgium)

These don't start from a procedural language (resp. from block
diagrams and from Silage) and have both some sort of library of
manually written code-pieces. They also perform some sort of global
scheduling. Anyone used these ? What is their quality on real life
examples ?

You can reply by email or post a follow-up (don't include this whole
thing !).  If I get significant answers, a summary will be posted.

+----------------------------+-----------------------------------+
| Johan Van Praet            |           IMEC , Kapeldreef 75    |
| vanpraet@imec.be           |           3001 HEVERLEE , BELGIUM |
+----------------------------+-----------------------------------+
|In theory, there is no difference between theory and practice.  |
|But, in practice, there is.                                     |
+----------------------------------------------------------------+
--
+----------------------------+-----------------------------------+
| Johan Van Praet            |           IMEC , Kapeldreef 75    |
| vanpraet@imec.be           |           3001 HEVERLEE , BELGIUM |
+----------------------------+-----------------------------------+
|In theory, there is no difference between theory and practice.  |
|But, in practice, there is.                                     |
+----------------------------------------------------------------+