🚀 go-pugleaf

Hi all!

I have some problems with programming a Tektronix 2212
Oszilloskope throu an IEEE-488.2 Interface.
The controler card is from National Instruments (AT-GPIB).

When i use this Oszilloskope with the fastest Samplingrate
20Megasamples/sec in the Triggermode SGLSweep it will
take 0.5 Secounds to read the waveform after the received
MAV Bit.
Is there someone who has experince in the Tektronix 2212
and programming the IEEE488.2 Interface of this Skope?
Or is there somone from Tektronix reading this Newsgroup,
who can say me something about the Performance of the
IEEE488.2 Interface in the Tektronix 2212?
thanks in advance

--
tobias voegele
 voeg@rz.uni-karlsruhe.de
 md15@rz.uni-karlsruhe.de

You can respond either to me or to the following adress:

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
-                                                            -
Dipl.-Ing. Gerhard Bosch M.Sc.-------voice:(0721) - 608 3118 -
Institute for Hydromechanik            FAX:(0721) - 608 4290 -
University of Karlsruhe                                      -
Kaiserstrasse 12                                             -
7500-Karlsruhe                                               -  
Germany                                                      - 
-                                                            -  
- Internet: bosch@ifh-hp2.bau-verm.uni-karlsruhe.de          -
-   Bitnet: nd07@DKAUNI2.BITNET                              -
-    X.400: S=bosch;OU=ifh-hp2;OU=bau-verm;P=uni-karlsruhe   -
-           A=dbp;C=de                                       -
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++