Is anybody using the DSP56ADC16?

Thread View: comp.dsp

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by George Vokalek Wed, 07 Nov 1990 01:14

#1072

Author: George Vokalek
Date: Wed, 07 Nov 1990 01:14

34 lines
1684 bytes

I have a query about the Motorola DSP56ADC16 Sigma Delta converter which
someone may be able to answer.

My datasheet has an errata sheet which was printed after the main
data sheet, showing a circuit apparently connected between FSO and
Vin(-).

The circuit is a series 10uF and 680R.  This represents quite a low
impedance connecting a digital frame sync signal to the analogue
signal input of the converter.  The errata sheet states:

'For optimum small signal performance from your DSP56ADC16, the following
circuit addition is recommended.  This external circuitry may be omitted
on the subsequent mask revisions.'

The errata sheet applies to mask C41C only.  Now I am using mask revision
2C35R.

Does the RC circuit connect Vin(-) and FSO, or Vin(+) and FSO via the
0.0047uF cap?  The omission of connection 'dots' in the wiring makes
this unclear, though I am reasonably sure that the former is correct.

What is the purpose of this circuit? (some sort of dither generator?)

After wiring up my system, I find that I am getting noise in the system
with an RMS value of about 20lsb, even when the inputs are shorted
together.

This strikes me as being rather poor.  I have followed all of the
guidelines (few) in the datasheet.

Does anyone have any recommendations for minimising noise in the DSP56ADC?

 ..G..

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads