🚀 go-pugleaf

Hallo.

Paul (amazon@user1.channel1.com) wrote:

: I recently performed a couple of upgrades to my PC and now my X1541
: cable does not work! Damn PC's!
The problem isn't the cable but the software. What program do you use,
X1541, Trans64 or The Star Commander.
The last two should work with the P-Overdrive but the first one wouldn't (I
think)
Also you should get the latest Version of Trans64 (1.24) or SC (0.71).

: Based on the documentation I have been reading, I tend to think that
: the interface card may be screwing up something with the Sync of the
: Printer Port? Could this be? If that is the case, maybe I sould buy a
: Sound Blaster Sound card which has an IDE interface on it, or would
: the same results happen?
The IDE-port has nothing to do with the LPT. The problem is the spped of
your new overdrive.


: Or, does a Pentium Overdrive Processor not work with the X1541 cable.
: I kinda find this hard to believe, but you never know. I have been
: using Star Commander which I thought automatically configures the
: timing for the PC. Do I need to slow the PC down? If so what is the
: best way.
You have to change the Delay. Start SCC and compare rthe value with the one
set in SC.

Greetings
	Bernhard Schwall