🚀 go-pugleaf

In dscribe, let's say you'd like to read in a 3D lattice from a plain
file with no header. Therefore, you'd like to enter xdim, ydim, and zdim
from parameters.

Next, you need to pass xdim, etc into the dims of the output lattice. 
Problem is, the parameters are three scalars, and the dims is an array.
I tried making subregions of the dims array (from 1 to 1, 2 to 2, 3 to 3),
but dscribe treats them as arrays even though there's only one component.

Is there a way around this? Is this fixed somehow in Explorer 2? When is
Explorer 2 due out?

Thanks a lot.

-- 
----------------------------------------------------------------------
Scott Ferguson                        Exxon Research & Engineering Co.
Project Engineer                      New Jersey
----------------------------------------------------------------------
"Always bark at a dog."