Changing option menu selection from SW?

Thread View: comp.graphics.explorer

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by John Hagedorn Wed, 26 Aug 1992 13:39

#104

Author: John Hagedorn
Date: Wed, 26 Aug 1992 13:39

11 lines
858 bytes

I notice when I use the GenLat module that when I select
one of the curvilinear choices from the "Coord Type" 
menu that the "Coord Representation" option menu changes
itself to curvilinear.  I haven't been able to find a 
call for changing the current selection in an option 
menu.  How is this done?

Thanks.

John Hagedorn   NASA/GSFC   hagedorn@betsy.gsfc.nasa.gov

Re: Changing option menu selection from SW?

#109

Author: Robert Brown
Date: Fri, 28 Aug 1992 16:19

18 lines
1109 bytes

In article <1992Aug26.093955@betsy.gsfc.nasa.gov>, hagedorn@betsy.gsfc.nasa.gov (John Hagedorn) writes:
|> 
|> I notice when I use the GenLat module that when I select
|> one of the curvilinear choices from the "Coord Type" 
|> menu that the "Coord Representation" option menu changes
|> itself to curvilinear.  I haven't been able to find a 
|> call for changing the current selection in an option 
|> menu.  How is this done?

The routine GenLat uses is cxInWdgtLongSet.  The line of code, specifically
from GenLat.c, is

        cxInWdgtLongSet("Coord Representation", CoordTypeNeeded);

Where CoordTypeNeeded is a long.
---------------
Robert L. Brown
Silicon Graphics, Inc.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads