Multiple Copies of Same Geometry: How?

Thread View: comp.graphics.explorer

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Matt Hughes Fri, 16 Oct 1992 17:07

#167

Author: Matt Hughes
Date: Fri, 16 Oct 1992 17:07

16 lines
1192 bytes

I want to write a module with one geometry port, and a lattice
port, and copy the geometry to each of the coordinates of the lattice.

There are routines for creating new geometries, but I haven't found
anything for modifying or copying old ones.  I could fan out hundreds
of connections to a geometry translating, scaling, coloring, etc. module,
but I'll pass.

I'll brace myself for an obvious answer.

Thanks.
-- 
Matthew V. Hughes - MN Supercomputer Institute  Graphics Support Coordinator
Minnesota Supercomputer Center, Inc.            Phone Number: (612) 626-1765
1200 Washington Avenue South                    hughes@msc.edu
Minneapolis, MN 55415                           hughes@msi.umn.edu

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads