🚀 go-pugleaf

Hi,

	I have a problem using the (shareware) Fitted Technologies
Modula-2 compiler and I was wondering if anyone in here could help.

	I've already checked the FAQ as well as several books, all
without success.

	I should also state that this is my first Modula-2 program
and have had to fight to be allowed to use this language. So, please
folks, don't let me down.  ;-)

	I need to include some DSP assembly language into my Modula-2
program. So far I've discovered that I need to use a "code" statement
for each assembly language opcode, e.g. CODE(57).

	However, when this was put into the program, the compiler seemed
to accept the command word "CODE" but then barfed at the "5", giving an
"unknown id" error message.

	I really need the following questions answered.

	1. Is it possible to include non-Intel opcodes in a Modula-2
	   program that is being compiled on a standard Intel-based PC ?

	2. If so, do I put the assembly opcodes into a separate module ?

	3. How do I "transfer" control to the assembly opcodes, let them
	   run to conclusion and then return control back to the Modula-2
	   program ?

	   e.g. do I use TRANSFER/IOTRANSFER, NEWPROCESS/PROCESS ... ?

	As I stated previously, all that I could uncover so far was that
it was necessary to use the "CODE" instruction. However, that was shown
using Intel opcodes.

	If anyone can offer some answers to these problems could they please
reply to :-

	selliott@cs.strath.ac.uk

	Thanks very much in advance for any help given.

Stuart