Change AppleLaserwriter baud rate

Article View: comp.lang.postscript

Article #1156

Back to comp.lang.postscript Previous Next

#1156

From: Daniel Ehrlich
Date: Thu, 05 Oct 1989 14:55

15 lines
1319 bytes

Would some kind soul out there be willing to send me the Postscript
code one would use to permanently change the baud rate for an Apple
LaserWriter.  Would the same code work in both the LaserWriter+ and
the newer NTX II?  Thanks in advance.

Dan Ehrlich <ehrlich@cs.psu.edu>   | "A message is not a message until the
The Pennsylvania State University  | rules for interpreting it are in the
Department of Computer Science     | hands of the receiver."
University Park, PA   16802        |    --Apollo Belvedere Smith

-- 
Dan Ehrlich <ehrlich@cs.psu.edu>   | "A message is not a message until the
The Pennsylvania State University  | rules for interpreting it are in the
Department of Computer Science     | hands of the reciever."
University Park, PA   16802        |    --Apollo Belvedere Smith

Technical Details

Message-ID: <1989Oct5.145526.3269@psuvax1.cs.psu.edu>

Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!psuvax1!psuvax1.cs.psu.edu!ehrlich

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!psuvax1!psuvax1.cs.psu.edu!ehrlich
From: ehrlich@psuvax1.cs.psu.edu (Daniel Ehrlich)
Newsgroups: comp.lang.postscript
Subject: Change AppleLaserwriter baud rate
Message-ID: <1989Oct5.145526.3269@psuvax1.cs.psu.edu>
Date: 5 Oct 89 14:55:26 GMT
Sender: ehrlich@psuvax1.cs.psu.edu (Daniel Ehrlich)
Reply-To: ehrlich@psuvax1.cs.psu.edu (Daniel Ehrlich)
Organization: Department of Computer Science, Penn State University
Lines: 15