🚀 go-pugleaf

My appologies if I haven't mastered the intricacies if Internet - this
is my first response to a public message and I've only been set up for
two days...
 
Assuming this might get lost because of bad addresing, the message is
a response to a fellow trying to link Turbo Prolog with Turbo Pascal.
 
I provide service for Borland and the Prolog Development Center on
CompuServe (PDC Prolog use to be Turbo Prolog).
 
As I recall, the initialization code between Turbo Prolog and Turbo 
Pascal creates potential conflicts in certain areas so this is not a 
highly recommended approach. Better to use a C/Prolog link since Turbo 
Prolog was written on a C foundation.
 
Jeff Dunteman, who now runs PC Techniques magazine and used to run 
Borland's short-lived Turbo TECHNIX magazine, published an article in
Turbo TECHNIX that included code that translated Turbo Pascal TPUs to
OBJ code. It may still be available through Borland or by contacting Jeff 
at PC Techniques. Other than using this approach, I know of no other that 
would solve your problem directly.
 
The folks at PDC Atlanta are very knowledgeable and ready to help if
you would like to ask if they have the code or can offer another 
solution. You can contact Michael Alexander at (404) 873-1366 and he will 
be in the best position to answer your question and provide the most 
suitable solution available.

Claude Duguay              cduguay@lcraft.ersys.edmonton.ab.ca