🚀 go-pugleaf

In article <778@fornax.UUCP>, donaldo@fornax.UUCP (Don Smith) writes:
> I would like to reverse engineer a calculator watch but am having
> a hard time removing the epoxy coating the chip.  So far I have 
> tried a number of chemicals including: 
>    acetone

	If you are dealing with a true epoxy compound (as opposed to say,
a thermoformed polymer), you are generally barking up the wrong tree using
acetone or other ketones (such as MEK, methylethyl ketone).

>    and hydrochloric acid.
> The hydochloric acid removed the epoxy but also damaged the chip.

	Not at all surprising!

> I would appreciate the names of chemicals which
> can break up cross linked polymers without damaging the chip.  The
> watch is an inexpensive OEM type watch costing about $10.

	I can give you the names of two chemicals to try which I have
personally used in years past for this purpose: dimethylformamide (DMF)
and 1,4-dioxane.  Your mileage will vary depending upon the actual
epoxy that has been utilized.  HOWEVER, THESE CHEMICALS ARE EXTREMELY
HAZARDOUS and should only be used in a properly constructed fume hood
by technically competent persons.  Don't even THINK of trying to use
these chemicals at home!

Larry Lippman @ Recognition Research Corp.  "Have you hugged your cat today?"
     {boulder||decvax||rutgers||watmath}!acsu.buffalo.edu!kitty!larry
VOICE: 716/688-1231 || FAX: 716/741-9635  {utzoo||uunet}!/      \aerion!larry