🚀 go-pugleaf

In article <1993Jan5.231843.26522@mlb.semi.harris.com> sonny@trantor.harris-atd.com (Bob Davis) writes:
>	I have a single frequency monitor which needs a 60 Hz
>vertical sync frequency. During boot up my computer evidently
>uses a 70 Hz vert. freq. so the monitor rolls vertically during
>this period. This continues until I can load a driver in CONFIG.SYS
>to change the video mode, or until a mode-changing utility can be
>invoked in AUTOEXEC.BAT.
>
>	Is there any way I can force a given video mode during
>the boot-up phase? Where is the video mode set during the initial
>boot? Is some standard mode always used? If so, what mode is it?
>
>	Thanks.
>
Its probably not the system as much as the video card you have since you can fix
it by loading a device driver (which I assume came from the video card maker).
See if there are any switches on the card that you can set to force it into a
different default setup. 

---JRE---


>_____________________________________________________________________________
>Bob Davis, UofALA alum \\ INTERNET: sonny@trantor.harris-atd.com  |  _   _  |
>Harris Corporation, ESS \\    UUCP: ...!uunet!x102a!trantor!sonny |_| |_| | |
>Advanced Technology Dept.\\ AETHER: K4VNO          |==============|_/\/\/\|_|
>PO Box 37, MS 16/1912     \\ VOICE: (407) 727-5886 | I SPEAK ONLY | |_| |_| |
>Melbourne, FL 32902 USA    \\  FAX: (407) 729-3363 | FOR MYSELF.  |_________|
>


-- 
Jim Erickson             ZZZZ EEEE  OO   SSSS   ZEOS International, Ltd.  
support@zeos.com   INET     Z E    O  O S       Technical Support Dept.
uunet!zeos!support UUCP    Z  EE   O  O  SSS    1301 Industrial Blvd. N.E.
Any opinions expressed    Z   E    O  O     S   Minneapolis, MN 55413