🚀 go-pugleaf

Here's the Setup First.
486/66 16 meg ram 
Side Jnr PRO EIDE Vesa card.
3 H/D's, all seen at boot time and all partitions seen at boot time.
Running slackware 2.2.0.1.

I can't mount any partitions on my 3rd hd. (/dev/hdcx   where x is 
partitions number)

I have the partitions set up in /etc/fstab the same as my other 2 h/d's 
that all have a least 1 dos partition on them that I can mount fine.
I have the mount points created and using the same command as I mount my 
other drives with (that works) by just changing the dev name and the 
mount point give me this:

husky:~# mount -o defaults -t msdos /dev/hdc8 /dos/h
mount: fs type msdos not supported by kernel

Which is dumb as i know my kernel supports msdos as I used the same 
command to mount 2 other dos partitions.

That device in /etc/fstab looks like 
this: /dev/hdc8        /dos/h        msdos        defaults   1   1

I can use the same mount command to mount all my other dos partitions, 
but I cannot access anything on my 3rd drive. That really is a pain as it 
is an 850Meg WD! All the partitions are seen on booting linux just fine, 
but I cannot mount them..

HELP!!!!

Please e-mail response as I'm keen to get my 850 working with linux.

Regards..

--
        Ross Irvine             s9312688@arcadia.cs.rmit.edu.au
                      3rd Year Computer Science
                RMIT. Melbourne, Victoria, Australia
   "I am Pentium of Borg.  Division is useless.  You will be approximated!"