🚀 go-pugleaf

In article <529bst$1bs@apakabar.cc.columbia.edu>,
Frank da Cruz <fdc@watsun.cc.columbia.edu> wrote:
: ...
:  2. I assume you are dialing or Telnet'ing out with Seyon.  In that case,
:     you have to pass the file descriptor that Seyon is using for the
:     connection along to Kermit, using "-j n", where n is the numeric
:     file descriptor (for a serial connection) or "-F n" (for a Telnet
:     connection).
:
Sorry, that should be "-l n", not "-j n".

: If Seyon does not give you a way to access and pass along the file
: descriptor, but it starts up the Kermit program with its standard i/o
: redirected to its (Seyon's) communications file descriptor, you can also
: experiment with the following method, which worked here in brief tests on
: SunOS.  Instead of having Seyon use "kermit -r" or "kermit -s filename" as
: its Kermit protocol commands, use something like this:
: 
:   For serial connections:
: 
:     kermit -YqQj 0 -r                     <-- to receive
:     kermit -YqQj 0 -s filename(s)         <-- to send one or more files
: 
Again, that should be "-l", not "-j":

    kermit -YqQl 0 -r                     <-- to receive
    kermit -YqQl 0 -s filename(s)         <-- to send one or more files

: Command line options:
: ...
:   l 0  - transfer files using file descriptor 0 for a serial connection
:   F 0  - transfer files using file descriptor 0 for a Telnet connection
:
Note: "l", not "j".

- Frank