🚀 go-pugleaf

A response on this recently was:
"You may have to set the options for the module. On one of the computers

I look after has 2 ne2000 cards. /etc/conf.modules looks like this:

alias eth0 ne
alias eth1 ne
options ne io=0x300,0x340 irq=5,9

i.e. specify the options for both cards on the one options line. "

My firewall has 2 different net cards, conf.modules has:

alias eth0 ne
options eth0 io=0x280
alias eth1 eexpress
options eth1 io=0x300

Mark Vandersteen wrote:

> >I have an "append ether=0,0,eth0 ether=0,0,eth1" in my lilo.conf
> >
> >I have
> >alias eth0 via-rhine
> >alias eth1 via-rhine
> >in my conf.modules.
> >
> >On bootup, the eth0 is initialised, but I get a
> >Delaying Eth1 initialization
> >for the eth1 interface.
> >
> You should only have to put the second eth1 in the lilo.conf file
> append = "ether=0,0,eth1"
>
> is what I have for 2 cards :) (there are different ones however)
>
> Mark Vandersteen mvanders@picknowl.com.au
> Powered by Linux !  Obsessed with women !
> The thoughts here are not necessariy mine !

--
*************************************************
   Jeff Evans             jevans@aidinc.com
Audio Intervisual Design   phone 323 845-1155
  Los Angeles, CA          fax   323 845-1170
*************************************************