🚀 go-pugleaf

Olivier Alessandri (olivier@antigone.neveux.fr) wrote:
: Avec un - OLITEC self memory 33600 - et sa passerelle - mgetty1.0.0 -
: (sous linux 2.0.29) je n'arrive pas � configurer mgetty pour que le
: faxmodem fonctionne en mode fax et modem .


Il est n�cessaire de modifier le policy.h pour que les modems Olitec 
de poche recoivent des fax... 
En clair, il faut utiliser controle de flux soft pour la reception 
et l'emission, et il faut fixer � une certaine vitesse le modem
(voir FAX_RECV_SWITCH)

Voici un diff:
--- policy.h-dist	Wed Mar 20 10:18:09 1996
+++ policy.h	Sat Jun 22 12:35:08 1996
@@ -396,7 +396,7 @@
  * in most of the received faxes.
  * Most faxmodems expect Xon/Xoff, few honour the RTS line.
  */
-#define FAXREC_FLOW	FLOW_HARD | FLOW_SOFT
+#define FAXREC_FLOW	FLOW_SOFT
 
 /* And this is for sending faxes
  *
@@ -415,7 +415,7 @@
  * that fax sending will time out after the first page sent (no ACK received)
  * and fail if FLOW_HARD is used. Use FLOW_SOFT instead.
  */
-#define FAXSEND_FLOW	FLOW_HARD | FLOW_SOFT
+#define FAXSEND_FLOW	FLOW_SOFT
  
 /* if your faxmodem switches port bit rate just after sending the "+FCON"
  * message to the host, define this to contain the baudrate used. (Not
@@ -428,7 +428,7 @@
  * starts the fax receiver, and times out waiting for OK, receiving
  * nothing or just junk.
  */
-/* #define FAX_RECV_SWITCHBD 19200 */
+#define FAX_RECV_SWITCHBD 19200
 
 /* some genius at US Robotics obviously decided that the above method
  * of switching baud rates is broken, and came up with something new

Amicalement.

--
Emmanuel DECAEN 
Ing�nieur Informaticien, T�l�com & R�seaux
Soci�t� Decaen - info@decaen.com - www.decaen.com - 04 76 91 81 25