🚀 go-pugleaf

LightningBit wrote:
> 
> I installed Redhat 5.0 (as a newbie) some days ago (no problems there).
> 
> after fooling around a bit, I decided to make a fresh installation, in
> EXACTLY THE SAME WAY like I did before :
> 
> the installation-set is on my 2nd harddrive (400 MB), (/dev/hdb1)
> I boot with the 2 installationdisk (boot-disk + supplemental)
> I create the necessar partitions on my first harddisk (1 GB) with Disk Druid
> (/dev/hda..)
> it formats the swap-partition without any problems,
> when asked, I give the path where the redhat-distribution is located
> (/redhat)
> and when he starts scanning the available packages, after a while he gives
> messages (corrupting the installation display) like :
> "install exited abnormally -- recieved signal 11"
> "sending termination signals ... done"
> "sending kill signals ... done"
> "unmounting filesystems ..."
> 
> and so on ...
> 
> any comments or a solution for my problem ??
> 
> thx,
> 
> Lightningbit

Check out Red Hat's "Product Errata" in their support section of their
web site.  It gives a way around this problem for those of us who
experienced it.

-- 
-------========++++++++++**********************++++++++++========-------
                         P120+ Cyrix 6x86, Win95 & RedHat Linux w/ CDE
Matt Harrell             Adaptec AHA2940 Fast SCSI-2 controller
mharrell@voyager.net     64MB RAM, 2.1GB EIDE and 1.28GB SCSI-2 disks
my.voyager.net/mharrell  Sound Blaster 16 PnP, 4X CD-ROM, SyQuest SyJet
                         Matrox Millenium II w/4MB WRAM, APC UPS-Pro 280
-------========++++++++++**********************++++++++++========-------


This article was posted from <A HREF="http://www.slurp.net/">Slurp Net</A>.