🚀 go-pugleaf

[[ This message was both posted and mailed: see
   the "To," "Cc," and "Newsgroups" headers for details. ]]

In article <37ec984c.2790201@news.erols.com>, <lksdjf@lskjdf.com> wrote:




> # 640x400 @ 70 Hz, 31.5 kHz hsync
> Modeline "640x400"     25.175 640  664  760  800   400  409  411  450
> # 640x480 @ 60 Hz, 31.5 kHz hsync
> Modeline "640x480"     25.175 640  664  760  800   480  491  493  525
> # 800x600 @ 56 Hz, 35.15 kHz hsync
> ModeLine "800x600"     36     800  824  896 1024   600  601  603  625
> # 1024x768 @ 87 Hz interlaced, 35.5 kHz hsync
> Modeline "1024x768"    44.9  1024 1048 1208 1264   768  776  784  817
> Interlace

These are the modelines. Delete the ones you either don't want or your
monitor doesn't support.


> # Device configured by Xconfigurator:
> 
> Section "Device"
>     Identifier  "My Video Card"
>     VendorName  "Unknown"
>     BoardName   "Unknown"
>     #VideoRam    16384
>     # Insert Clocks lines here if appropriate
> EndSection



> Section "Screen"
>     Driver      "svga"
>     # Use Device "Generic VGA" for Standard VGA 320x200x256
>     #Device      "Generic VGA"
>     Device      "My Video Card"

So, this is telling it to use "My Video Card" (the previous line is
commented out.


>     Monitor     "CTX 1765"
>     Subsection "Display"



>         Depth       32

Here's why you are running in 32 bit colour. Change this to 16



>         Modes       "1280x1024"

But only with mode 1280 x 1024. you need to add some more to this. Eg.

       Modes       "1280x1024" "1024x768" "800x600" "640x480"

will give you access to those additional resolutions. Again, make sure
your monitor supported the refresh rates in your modelines.


>         ViewPort    0 0
>     EndSubsection
> EndSection
> 

Mark