🚀 go-pugleaf

I have encountered the same problem (using SETUP.EXE from the CD-ROM).  I
talked to one of my techie friends who mentioned that I should NOT be
loading any type of DOS on the HD, just use a simple START disk (containing
FDISK, MSCDEX.EXE  and some other basic programs) and to use that to try to
load windows up.  I will try it again this weekend, but I'm tired of trying
and trying and trying...

If someone could tell me the correct procedure to installing windows95, I
would be very grateful.

Joe Meehan
Guardians@earthlink.net
Joeym2000@aol.com

Matt West wrote in message <3505799d.114182756@news.demon.co.uk>...
>I hope someone may be able to shed some light on this problem :
>
>When installing Windows 95 OSR2 (using the correct OEM preinstall
>tools), the installation routine freezes at the blue "Getting ready to
>run Windows for the first time" screen.
>The hardware is all new, and passes software diagnostic tests.
>Two new motherboards have been tried in this PC (both new LSI TX
>chipset boards) and the SIMMs have been replaced.  I have also tried a
>different hard drive.
>The only common part is the CPU, an IBM M2 P166+ MX.   Could this be
>the cause of the freezing ?
>