🚀 go-pugleaf

Mario, you need to set up each COM port with a separate IRQ and I/O port
address.  Otherwise the system will not know what it is supposed to be
addressing.  You will have to configure each COM port using either the
jumpers on the hardware, the BIOS settings, or by using the W95 Plug and
Play (PnP) capabilities, or a combination of these depending on what kind
of hardware you are running.   PnP requires that the hardware (BIOS/MB,
cards) and the operating system be PnP capable.  Good Luck!  Larry

mario <mario.graf@interunfall.telecom.at> wrote in article
<01bc3945$29e484e0$670c76c2@mariograf>...
> i have 4 comm ports in my computer (com1 to com4)
> com1&3 are IRQ 3
> com2&4 are IRQ 4
> 
> since 2 days i have a problem with com2&4 under win95
> 
> if i open an application that will use the modem (com2), the application
> says that
> the comm port is already open, but i haven�t startet a programm that uses
> the modem!
> 
> when i want to install my modem new, the auomatic installation in win95
> only looks at com3!! (com1=mouse, and com2 and 4 are opened?)
> in dos i can use all com ports without a problem!
> 
> is there a problem maybe with the registry???
> 
> thank you for your help and nice greetings from vienna
> 
> 
> mario :-)
> 
>