🚀 go-pugleaf

>We have a Zeos 486-66 with 16 meg ram that usd to be our fileserver. It 
>has been since downgraded to only a 600 MEG scsi drive, 16 meg ram. The
>Scsi contoller is an Adaptec 1542b. When I install windows 3.1 of the 
>network (lantastic) everything goes fine (the Zeos drive has been reformatted)
>and it installs fine. when I reboot the computer and try to run windows it
>shows the logo and then just exits to dos again. I tried running in in 
>standard mode and it works fine. (computer is using dos 6.2). I have also
>tried windows 4 workgroups without any success. When I boot with /b the 
>last lines of the bootlog are

>NOSDone=NOSDone
>NCD Done=NCD Done

>I have replaced the diamond vram card with a generic 1 meg card to see 
>if that was the problem, with no change. if there is anyone that has
>had a similar problem I would REALLY like to hear.. 

>Thanks.
>Troy Wollenslegel


>Troy Wollenslegel                               Limno-Tech, Inc.

I have a Zeos 486dx2-66 VLB with 16mg. I run wfw 3.11. I haven't used 
lantastic, but this machine has worked with wfw own networking, Netware Lite, 
and Netware 3.12....all without a hitch. I have a Diamond Viper card in there. 
TO try nailing down where the problem is, I woudl change to standard VGS, 
regardless of what video card is in there. I would also see if it boots 
without the network software. I don't have anything scsi, so I don't know 
what network/scsi issues there may be. 

==============================================================
   Barry A Barr            Chicago            barry@mcs.com
             FTP: ftp.mcs.net//mcsnet.users/barry
        Home Page: http://www.mcs.net/~barry/home.html
==============================================================