Creative Videoblaster RT-300 Setup

Thread View: comp.os.ms-windows.video

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by David Longley Wed, 27 Dec 1995 00:00

#37

Author: David Longley
Date: Wed, 27 Dec 1995 00:00

15 lines
1285 bytes

I've  spent the best part of the day trying to set up a  Creative 
Videoblaster RT-300 on a P120/Endeavour Board based system. I have
used a Miro in the past and had no problems with that..

I  have tried the deafult settings (IRQ 10 and Address 2E4H)  and 
I  made  sure IRQ 10 was allocated to an ISA slot.  I  Have  also 
tried IRQ 12 and 340H).

When  I enter LE Premiere, and try CAPTURE, I just get a  message 
that  the driver can't be accessed. Is there any way of  checking 
out that the card is OK??

Anyone else experienced this problem?
-- 
David Longley

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads