🚀 go-pugleaf

In article <6762@gara.une.oz.au> dwright@gara.une.oz.au (Denis Wright) writes:
>I have printer initialization problems. Perhaps someone can help. I 
>have an Epson LQ400 printer, an AT compatible (Taiwanese EMK-286V) 
>...
>The problem is that, unless I boot up with the printer already on 
>(which is very rare for me), it won't initialise when I do switch it 
>on. The power light comes on, but that's all. If I fiddle about 
> ...

I had a similar problem with a Dell 310.  Dell's excellent hotline
came through again with the advice to put an isolator in the lpt line
going to the printer.  They had such for $20 (I think) so I gave my VISA
number and it appeared in a day or two.  Voila, problem solved.  The
isolator turned out to be a male-female DB25 adapter (zero-length cable)
that had a 220 ohm (I think) resistor in every line!  I don't know
whether these beasties are purchasable at your corner computer store.
             .---------------------------------------------------------------- 
            /Internet email: sher@bbn.com
Larry Sher <        US Mail: BBN, MS 6/5A, 10 Moulton St., Cambridge, MA 02138
            \     Telephone: (617) 873 3426    FAX: (617) 873 3776
	     `----------------------------------------------------------------