🚀 go-pugleaf

mulligan@jcpltyo.JCPL.CO.JP (Raymond) writes:
}The machine has 4Mb of memory, I installed the same Xview on an 8Mb machine
}and it works fine. (This machine was not a Compaq)
 Proably, you dont have 4MB available. If you're like most DOS people,
me included, you tend towards a 1MB disk cache, ten or twelve small tsrs..
(things like networks, video drivers, etc..) THat result in having something
*much* closer to 2.5 MB free for DVX to play with--- and that's a problem.

 Some tips to remember:
1) leave hma free-- the area that you are using to loadhi things is
also the area where DV/DVX wants to load it's code.... Remember that 
the amount of conventional memory left is the maximum program size you can run code in. Less is more..if you can't live without that tsr, run it in a 
dos windo, or make a dvp for it.

2) Allow Program swapping-- edit the dos4gfx.cfg file, and set virtual memory
on.... For some reason, Quarterdeck figured that you never really wanna
swap programs, just video. :)

3) Consider the program dvp's you're using..if you write them yourself, 
start at 350K available and move up...the less memory required by a dvp, the
more situations in which that program's gonna run...like, say, when you
install a network on that machine, and have alomost 50K less memory.
(Ack, poo. Lanman...*grrr*...but work has it's requirements)



}1) Should it work OK with 4Mb. I cannot open ANY application.
 It Will, if it's set up properly.

 Just some thoughts...

 mark