🚀 go-pugleaf

In article <45qqgn$j87$1@sydney.DIALix.oz.au>,
   John Savage <koala@sydney.dialix.com.au> wrote:
>osv@newcom.kiae.su (Sergey Ostashenko ) writes:
>
>>There is nothing in the Setup for booting from B:.
>>Is there a way to force booting from B:? Any software?
>
>You could swap the connectors around (and alter the setup) so that the
>3.5" drive becomes A:, otherwise determine whether one of these utilities
>will work for you:-
>
>ftp ftp.coast.net /Simtel/msdos/diskutil/
>bboot.zip     B    3182  930910  Boot from B: drive instead of A:
>boot_b.zip    B    4349  910626  Boots machine with A: and B: drives swapped

Enter the CMOS setup (<delete> when starting usually) and put b: before c: in 
the bootup sequence. The computer automatically tries to load from the B:, if 
it fails, i.e. no disk in drive b:, then it boots from the hard drive. Most 
computers are already setup this way, so that you can start the computer in 
case of hard disk problems.

Regarsds
Russellb

Rampages are not only for postal workers anymore!