Help

Thread View: comp.os.msdos.misc

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Rod Hart - WA3MEZ Sun, 03 Jan 1993 16:46

#2875

Author: Rod Hart - WA3MEZ
Date: Sun, 03 Jan 1993 16:46

32 lines
1484 bytes


When I change floppies on my system, I get a volume ID change yet
the directory contents remain unchanged. I can force a change by
hitting a Cntl-C. I have swapped both drives and controller cards as
well as verified the DC options are in place on both drives. The
system is configured as follows:

Acer 486dlc 33Mhz Motherboard with Math Coprocessor
8 Meg. Memory
200 Meg. Maxtor Hard Drive
3" TEAC Floppy Drive
5" TEAC Floppy Drive
Hitachi CDR-3600 CD Rom Reader
CMS 250 Tape Reader
Soundblaster board
Internal Modem
Mainlan Ethernet Card
Trident 8900C Video
MSDOS 5

I have run test without autoexec.bat and config.sys installed as
well as disabled shadow rom and caching to make sure there were no
unknown interdependencies. The system will reliably recognize the
changing of disk volumn, yet the directory contents will remain
unchanged. I have no idea of what to do next. Any help would be
appreciated.

				Rod Hart wa3mez
                                wa3mez@wa3mej         - Packet Radio
                                hart@cp1.bell-atl.com
                                hart@wb3ffv.uucp

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads