🚀 go-pugleaf

I recently installed Stacker 3.0.  I did not have stacker before.
I use a Ram Drive D: for a ( out of Geos Dos application ).
I have Stacker all configured and running fine with drives,
C: D: and E:  Stacker made the RAM drive D: and the Stacked disk E:

Everything works fine with my config.sys tuned..... Except....

When I go into Geos and only when I first open the GeoManager it says
It can not find the directory check your drive location (or something to that
effect)  I click on OK and the geo manager is blank, I click on the World
icon and poof the manager is all there. hmmmm and is fine until I exit and
restart geos again and only when I reopen the manager.

When it first opens it shows it is looking at D:[stak_vol]  then when
I have clicked on the world icon it comes up with C:[stak_vol]

2 possibles...... 1) I have the ramdrive D:  2) It is stacked also in the
config.sys
( 1024 ramdrive gets doubled to over 2meg COOL!)  
Maybe geos has trouble finding it at first.  The main program loads up fine.
It just can't find the world at first opening it.

Any suggestions.?  I am continuing to try different combinations to see
if geos can remember... Is there some setting I can do or set.?

C-ya..... /\/\artin

--
  This communication is sent by    /\/\artin   University of Arizona Tucson
  =========================================================================
  ak333@cleveland.freenet.edu   mlinsenb@ccit.arizona.edu  mlinsenb@arizvms
  DEATH HAS BEEN DEAD FOR ABOUT 2,000 YEARS ****** FOLLOW THE KING OF KINGS