🚀 go-pugleaf

In article <3817@altos86.Altos.COM> rcollins@altos86.UUCP (Robert Collins) writes:
>In some article, it was written:
>+}  In my Infoplus program, the 286/386/486 are detected by trapping the
>+}invalid opcode interrupt, and then trying instructions. 
>[but there are lots of places where this doesn't work very well, either
>because someone else gets the trap, or because some putatively unused opcodes
>do secret things.]

The Intel 486 Programmer's manual has sample code to tell the difference
among the 8086, 286, 386, and 486 without any trapping at all.  There are
lots of differences other than new instructions.  For example, on a PUSH SP,
the 8086 pushes the decremented SP but newer processors push the original
value.  When you push the flags register with PUSHF, the 8086 always sets
bits 12-15 to one, the 286 always sets them to zero, and the 386 and 486
store some actual flags there.  The 486 uses flag bit 18, which the 386
didn't.  Intel provides sample code that is straightforward and doesn't
depend on catching traps.  Looks good to me.

-- 
John R. Levine, Segue Software, POB 349, Cambridge MA 02238, +1 617 864 9650
johnl@esegue.segue.boston.ma.us, {ima|spdcc|world}!esegue!johnl
Marlon Brando and Doris Day were born on the same day.