🚀 go-pugleaf

I've been reading and reading and scouring thru the indexes looking for ways 
to read switches and input from the command line under TP 5.5

What I'd like to do is something like : 
   program info info info
and be able to read the info info info into the program and act upon it.

The program itself works fine in its current state, both with hardcoded data 
AND with datafile for its input, but what I really need is command line 
control.

Does anyone know of anything like this or how to do it?  A unit that I could 
use would be GREAT, however, just the way to do it and the commands I would 
need would be fine...in fact ANYTHING to get this going would be helpful.

Thanks for your help in advance...

Please reply via Email to ZETA@yngbld.tfsquad.mn.org (see the signature 
below) as I do not have access to read these groups from here...

thanks for any help you can offer.

Greg

__________________________________________________________________________
!  Gregory S. Youngblood   !   The opinions expressed above are my own   !
!  TCS Consulting Services !   and does not mean I'm right or that anyone!
!__________________________!   else agrees with me.                      !
!  42... The only answer.  !_____________________________________________!
!________________________________________________________________________!
!  zeta@yngbld.gwinnett.com           ..!emory!gwinnett.com!yngbld!zeta  !
!  zeta@yngbld.tfsquad.mn.org             ..!tfsquad.mn.org!yngbld!zeta  !
!                                           ..!emory!cowpas!yngbld!zeta  !