🚀 go-pugleaf

Hi Netters,

Can someone outthere please help me with the following question concerning
the XMS function 2Fh, sub-function 0Bh (Move Extended Memory Block).

This function can be used to move blocks of extended memory, that are allocated
by using function 2Fh sub-function 09h. It could however also be used by moving
blocks of data in conventional memory to or from extended memory, so the manual
says.
The structure used by the MoveExtendedMemory function to identify the memory
blocks is pictured below.

stuct {
    long length;		/* length of block to move */
    short sourceHandle;		/* handle of block to move */
    long sourceOffset;		/* ??? */
    short destHandle;		/* handle of block to move to */
    long destOffset;		/* ??? */
} XMS_move_struct;


My question is:
    a)	What does this 'sourceOffset' and 'destOffset' mean, because the 
    	AllocateExtendedMemory function only returns a 'handle' on success.
    b)	What 'handle' do i specify when moving data between conventional
    	memory and extended memory?
    c)	Do i use the correct function at all?

I am a junior in XMS/EMS programming, so all advice is gratefully accepted.


Tanks in advance,
Henk Kotmans