🚀 go-pugleaf

In article <6232@videovax.tv.tek.com>, dougs@videovax.tv.tek.com (Doug Stevens) writes...
|> 
|>I have used both MAKE with TCC and project-make within TC. The project
|>make appears to be MUCH (much, much ...) faster. I speculate that the main
|>difference is that when running MAKE, TCC must be re-loaded every time that 
|>a dependency triggers a compilation, and that TC loads the compiler only once
|>before checking dependencies and compiling.
|> 
|>I also prefer the project make because I don't have to maintain dependency
|>lists in the makefile (even with automated tools, such as Polymake, you have
|>to remember to run the tool to update the dependencies).
|> 

Turbo C++ needs *lots* of memory. I used to think MAKE was slow until I  found
the -S switch. This switch swaps MAKE out while executing commands (significant
memory saver). Also, using the -Qx switch on the compiler helps if you have
extended memory (-Qe is the default if you have expanded). Also, running MAKE
underneath the IDE (using the DOS shell command) will severly limit compilation
performance. Don't forget the -a switch (or .AUTODEPEND directive) to tell MAKE
to automagically check the .OBJ files for dependencies.
---
Barry L. Wallis			USENET: wallis@labc.dec.com
Database Consultant		Prodigy (don't laugh): DNMX41A
U.S. DECtp Resource Center	DECUServe: EISNER::WALLIS (not on the net yet)
Los Angeles, CA			"No one voted for me, I represent myself"
---