🚀 go-pugleaf

In article <8256@ucdavis.ucdavis.edu> chiang@iris.ucdavis.edu (Tom Chiang) writes:
>
>following below is asm code for a tsr with a few lines added by me...
>the tsr basically intercepts int 16 and changes the case of the
>letter Y whenever it it is typed....now, i added code to send the 
>letter z to printer every time this int occured...but my system
>crashes from those new lines...any help would be appreciated

This is called the DOS re-entrancy problem which anyone who is teaching
you to write TSRs should have told you about. Simply speaking, DOS
cannot be entered twice. Since the int 16h request most likely comes
from inside DOS, issuing another DOS call destroys the stack of the
first call thus causing the system to crash. (Actual situation is more
complicated since DOS uses several stacks. Try to get some books on this
subject. Unfortunately, I can't think of any good books on writing
TSRs. Has anyone seen one?)

Changing your code to the following may work:

; push/pop ax/dx as needed...
	mov ah, 0		;output char to printer function
	mov al, 'z'
	sub dx, dx		;(lpt1) 
	int 17h			;BIOS printer output interrupt

>	push dx ----- 
>	push ax     | 
>	mov dl,'z'  |
>	mov ah,5H   | ----- these are the instructions i added
>	int 21H     |
>	pop ax      |
>	pop dx ------

Good luck!

yawei