🚀 go-pugleaf

In article <valley.668976840@gsbsun>, valley@uchicago (Doug Dougherty) writes:
> rkl@cbnewsh.att.com (kevin.laux) writes:
> 
> >	RETF is used when interrupt handlers want to return one of the Flags
> >bits.  The INT instruction pushes the Flags onto the current stack, then CS,
> >then IP.  When the interrupt handler uses the flags bits to return success,
> >failure or whatever, it cannot use an IRET as this will end up popping the
> >old flags off the stack destroying the bits that were purposely set up.
> >The RETF 0002h instruction will pop CS:IP off the stack and then will discard
> >two bytes.
> 
> I think you are wrong.  (Purely conjecture, since I haven't debugged the
> code, of course).  I think routines that return information in the
> flags (such as, e.g., almost all of the INT 21 routines) do it by
> manipulating the word on the stack itself (at, I believe, [SP+4]), so
> that the final IRET returns a diferent flags value than the one
> originally pushed by the INT instruction.

	Yep - is purely conjecture.  Debug/unassemble your BIOS and you'll
find what I said is exactly correct.

-- 
________________________________________________________________________________
	R. Kevin Laux				Email: rkl1@hound.att.com
	AT&T Bell Labs				Voice: (908) 949-1160
	Holmdel, NJ 07733			Fax:   (908) 949-0959