🚀 go-pugleaf

Boy does that sound unfun!  You can definitely rem out the offending lines,
if you don't just save the current file and then create a new one...
In <5fnvrr$9s16$1@news.goodnet.com> cengard@goodnet.com (Craig M. Engard) writes:

>Hello all,
>I installed the 410pt7 on two 4.1 servers using the Install.nlm method, 2 
>questions:

>1) The install left the #6 patches in the Autoexec.ncf, so every time the 
>server boots, there is a list of 'Skipped, already loaded' messages displayed.
>Is it supposed to do that, or can I REM out the #6 loading in the 
>Autoexec.ncf?

>2) I have a Hayes Driver NLM (for their high speed serial board) that now 
>abends the server when trying to load.  Hayes has no new driver.  I'm using 
>Novell's Aiocomx.nlm until I find a solution.  This limits me to 2400bps on my 
>GroupWise Gateway connections.  I'm considering droppiong back to the #6 
>patches un	til a solution is found.  So, the question: can I just 
>re-install the 410pt6.exe and be back to where I was or is this going to screw 
>up Server.exe?

>All thoughts appreciated.
>CraigE...

This is where everyone hopes you made a backup before applying the patch. 

My GUESS is that you could remove the lines calling for the new 410pt7 files,
and you would be back...

don't reinstall #6, that will just mess it up more...

Wayne
wwymore@efn.org

No, it doesn't remove the 410pt6 files or commands.  Simply REM these from
the STARTUP.NCF 

It sounds like you have an old AIO or AIOCOMX.  I have experienced similar
problems, and they were due to older AIO/AIOCOMX files.
--------------------------------
Chad Smith
System Engineer, Marshall & Poe LLC
(219) 266-5244 FAX (219) 262-5161
Email:csmith@marshallpoe.com

Craig M. Engard <cengard@goodnet.com> wrote in article
<5fnvrr$9s16$1@news.goodnet.com>...
> Hello all,
> I installed the 410pt7 on two 4.1 servers using the Install.nlm method, 2

> questions:
> 
> 1) The install left the #6 patches in the Autoexec.ncf, so every time the

> server boots, there is a list of 'Skipped, already loaded' messages
displayed.
> Is it supposed to do that, or can I REM out the #6 loading in the 
> Autoexec.ncf?
> 
> 2) I have a Hayes Driver NLM (for their high speed serial board) that now

> abends the server when trying to load.  Hayes has no new driver.  I'm
using 
> Novell's Aiocomx.nlm until I find a solution.  This limits me to 2400bps
on my 
> GroupWise Gateway connections.  I'm considering droppiong back to the #6 
> patches un	til a solution is found.  So, the question: can I just 
> re-install the 410pt6.exe and be back to where I was or is this going to
screw 
> up Server.exe?
> 
> All thoughts appreciated.
> CraigE...
> 
>