🚀 go-pugleaf

Tim,
True, misreading posts can become an occupational hazard.
I just wanted to point out that according to the manual TCPBEUI will
bind
to the first adapter it finds active. I have a setup where I want
TCPBEUI to
bind to the 2nd adapter(lan1). I have some ideas on how to achieve this
but would
appreciate any input,
Thanks,
Brian  

Tim Clarke wrote:
> 
> Hi Brian,
>     thanks for your reply, but I think you may have misread my post.
> 
> > Tim,
> > There are a couple of errors in this.
> > 1) the setup you have will only work because you have tcpbeui on 0,
> > if you want to make it go to 1 on a second nic card there is a problem.
> 
> True, that was what I describing in the post - the fact that TCPBEUI must be
> bound as logical adapter 0 to TCP/IP adapter lan0.
> 
> > 2) tcpbeui completly ignores the first comma.
> 
> It was NETBEUI that was bound as logical adapter 1, with the leading comma
> to cause this.
> 
> Thanks all the same.
> 
> > see INFO-TASKS-Network adapters and protocol guide.
> >
> > Brian
> >
> > > From recent experience on playing with TCPBEUI:
> > >
> > > 1) Only *one* LAN or SLIP/PPP adapter may be bound to TCPBEUI
> > >
> > > 2) The adapter to which you wish to bind TCPBEUI must be the *first*
> > > configured:-
> > >
> > > [NETBIOS]
> > >     Adapter0 = tcpbeui,0
> > >
> > > [TCPBEUI_nif]
> > >     DriverName = TCPBEUI$
> > >     Bindings = adapter0_nif
> > >
> > > [adapter0_nif]
> > >     DriverName = ????????$
> > >
> > > 3) TCP/IP must be bound to it! (Otherwise, where's the transport!!!)
> > >
> > > [TCPIP_nif]
> > >     DriverName = TCPIP$
> > >     Bindings = adapter0_nif
> > >
> > > 4) If you *also* wish to bind NETBEUI to the *same* adapter you must use
> a
> > > higher logical adapter no.
> > >
> > > [NETBEUI_nif]
> > >     DriverName = NETBEUI$
> > >     Bindings = ,adapter0_nif    <=== NOTE: leading comma defines *no*
> > > adapter "0" (has been used by TCPBEUI). This is adapter "1".
> > >
> > > 4) then you can set up OS/2 Peer to use these logical adapters
> > >
> > > [networks]
> > >
> > >     NET1 = TCPBEUI,0,...
> > >     NET2 = NETBEUI,1,...