🚀 go-pugleaf

SYSOP (brian_gold@towernet.net) spoke thusly:
: I am running OS/2 Warp Connect and Lan Server 4.0 with an Adaptec 2842
: controller with 2 Nakamichi 7 disc changers.  The problem I have having
: is that with disconnect enabled on the controller the changers will
: randomly start to rotate through the cd's.

: Is there anyone else having the same problem with either OS/2 or Win 95?

Well, mine one MBR-7 (Nak? Mountain? NEC, I forget <g>.) workied fine for the 
ten minutes I ran it on DOS6/Win31. I am now using it under NetWare 4.1.

I notice a HELL of a lot of swapping on bus reset (e.g. when the SCSI card 
driver loads - in this case it's a Future Domain TMC850, but I also used an 
AHA1542C. The Adaptec NetWare drivers don't support multiple LUN's, but I saw 
the same behavior.)

Perhaps, therefore, something is crashing and so the drivers are sending out a 
bus reset when the unidentified-bad-thing happens?
--
Home: dremu@emf.net     find me on the PSQ homepage http://www.emf.net/~quam
that's doctor emu          CDC SCSI and The Slosh on ftp.emf.net/users/dremu

Work: support@maxis.com     Maxis Software Toys: The SimCity People
Maxis -=- 2121 N California Blvd, Suite 600 -=- Walnut Creek CA 94596-3572
Voice  510.927.3521   FAX 510.927.3581   BBS 510.927.3910

                 Las llamas son mas grandes que las ranas.

and of course, the views expressed herein are those solely of the individual
and in no way are meant to express those of Maxis or any of its subsidiaries