Thread View: comp.os.os2.misc
1 messages
1 total messages
Started by Adam Frey
Wed, 04 Jan 1995 04:03
Stealth 32 and Warp Problems
Author: Adam Frey
Date: Wed, 04 Jan 1995 04:03
Date: Wed, 04 Jan 1995 04:03
33 lines
2311 bytes
2311 bytes
Here is a copy of some email I sent to Diamond tech support. Any help would be greatly appreciated. ------------------------------------------------------------ I am attempting to get my newly installed Diamond Stealth 32 video card to work correctly with OS/2 Warp and my Videocom monitor. I tried the 2.1 drivers supplied at your FTP site which not only didn't work but overwrote my svga.exe with a useless older version. I tried the ET4000w32 emulation with some success. However I continue to be unable to get correct horizontal alignment at 1024 x 768 x 256 60hz or above. When I use setmode to select a monitor with the same specs as mine, I get this slight alignment problem. When I use setmode to define my own monitor, I get no option for modes above 800 x 600 and most of the modes I am presented with (in the system settings notebook) do not work. I am experienced with monitor specs and have meticulously entered the details from the manual into setmode. The procedure I have been following is: setmode to configure monitor setmode monitor cd \os2 svga on (or alternatively svga on dos) Please help me to get a properly working setup and please inform as to when fully operational and functional stealth 32 drivers will be available for warp. -- - Adam Frey Private: adam@eden.apana.org.au - - Melbourne, Australia University: s932562@yallara.cs.rmit.edu.au - ---------- And if it wasn't for the bullet in my breast pocket... -----------
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads