🚀 go-pugleaf

In <DwvrF0.BoH@matilda.vut.edu.au>, johnr@warp.vut.edu.au writes:
>I hope I can get some help with the following problem.
>
>I'm trying to install Warp Connect Blue.  The installation procedure
>installs the OS fine and seems to install the networking component
>correctly as well (just TCP/IP 3.0 off the parallel port), but when the
>system automatically reboots I get the following trap
>
>==================================================================
>
>Exception in device driver: PROTMAN$
[snip]
>The system is stopped. Record all of the above information and
>contact your service representative.
>
>==================================================================
>
>If I remove the PROTMAN.OS2 line, Warp boots - but then I can't
>connect to my ISP.
>
[snip]

No final answers but,
 If installing Warp Connect over Warp with Bonus Pak TCP/IP,
 you need to remove TCP/IP 2.x first.

 Check LANTRAN.LOG.  There might be something useful here.

 Replace PROTMAN.OS2 with a known good copy.

 Check PROTOCOL.INI for "bad" or incorrect entries.

 CHKDSK

 
I suggest:
  Remove TCP/IP 2.x
  Check/edit CONFIG.SYS
  Install Warp Connect w/o networking 
  When up and running, then install Networking.
    (dbl.-check that parallel support is installing)

Hope some of these ideas gets you results.

Mark Vilez