🚀 go-pugleaf

In article <1993Jan3.054918.1861@netcom.com> daveb@netcom.com (Dave Briccetti) writes:
>U37127@uicvm.uic.edu () writes:
>: I have received E-mail (rob@cc.gatech.edu) saying that the thread
>: issuing the WinSendMsg must have a msg Q as well; I also received
          Yes.
>: another answer saying that a thread *cannot* use WinSendMsg
>: to a window belonging to another thread (lhoang@orion.uci.edu) and
>: that this behaviour is documented.  Apparently IBM recommends

          After I received E-mail reply from you, I have been trying to 
          find where I read this from the OS/2 2.0 Tech Lib - Programming 
          Guide Volume's, with no sucess.  I remember reading something like 
          "to send message to another thread, use WinPostMsg() ...",
          while I was writing a progress bar for the program upload/download
          ARTs from IBM mainframe to PC. I did not read PM Programming 
          Reference Vol 1 to point out the real difference
          between the implementations of the two. (Chapter 2. Messages and
          Message Queues - Programming Guide Vol 2, OS/2 Tech Lib, also
          discusses about the messages structures in PM environment.)

          I apologize for what you have been going through because of my 
          incorrect answer.

>: WinPostMsg.  Perhaps to maintain serialization via the msg Q

          "The WinPostMsg function creates a QMSG struture for the message
           and copies the message to the message queue corresponding to the 
           given window.
           The application's message loop eventually retrieves the message
           and dispatches it to the appropriate window procedure."

>: as opposed to WinSendMsg which is a direct call to the function?

          "The WinSendMsg function passes the message to the window
           procedure corresponding to the given window. 
           The function waits until the window procedure completes 
           processing and then returns the message results."

     Other quotes:
          "If the window receiving the message belongs
           to the same thread, the window function is called 
           immediately as a subroutine. If the window is
           of another thread or process, the operating system 
           switches to the appropriate thread that enters
           the necessary window procedure recursively.
           The message is not placed in the queue of the
           destination thread."

          "Any thread in the application can post a message to a
           message queue, even if the thread has no message queue of its own.
           However, only thread that has a message queue can send a message.
           Sending a message between threads is relatively uncommon. For one
           reason, sending a message is costly in terms of system performance."

      Your guess is right on the money.
>: 
>: Is there a definitve doc anywhere on this subject?  My interim kludge has been
>: to use WinPostMsg, with an app defined msg, and block until the receiver
        or to create a message queue and use WinSendMsg, if coding blocking
        becomes tedious.
>: processes the msg and shoves the result into a shared data structure.
>
>The notes in the PM Reference make it quite clear that WinSendMsg to a
>window belonging to another thread IS allowed.  The message is sent 
>synchronously and the thread switching is automatic.
   Yes.
>
>I've done it myself for years.
   Beginner in OS2 PM programming. I'll try to keep my mouth shut and do my
  homework better.
>
>-- 
>
>Dave Briccetti, Owner, Dave Briccetti & Associates
>OS/2 Developer/Consultant
>P.O. Box 1713
>Lafayette, CA  94549-7013

Long Hoang.