WorkFrame/2 debug kernel crashes

Thread View: comp.os.os2.programmer

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Rick Pack Wed, 22 Jul 1992 20:59

#416

Author: Rick Pack
Date: Wed, 22 Jul 1992 20:59

17 lines
1123 bytes

I just installed the WorkFrame/2 development software on my system.  Everything
seems to work just fine, with one exception.  After installing the debug kernel
and re-booting, the system crashes after just a few seconds.  (I was worried
I wouldn't be able to swap back to the normal kernel before it crashed.)

The crash completely locks up the mouse and ctl-alt-del doesn't work.  After
removing the debug kernel, all is fine again.

My system is a 33 mhz 486 with 16 megs of ram and an ESDI drive.

Thanks for any help.

-- 
Rick Pack   -WC7W- 
Evans & Sutherland Computer Corp.
Salt Lake City, Utah
(801) 582-5847

Re: WorkFrame/2 debug kernel crashes

#431

Author: Barry King
Date: Thu, 23 Jul 1992 06:46

23 lines
1649 bytes

rpack@javelin.sim.es.com (Rick Pack) writes:

> I just installed the WorkFrame/2 development software on my system.  Everythi
> seems to work just fine, with one exception.  After installing the debug kern
> and re-booting, the system crashes after just a few seconds.  (I was worried
> I wouldn't be able to swap back to the normal kernel before it crashed.)
> 
> The crash completely locks up the mouse and ctl-alt-del doesn't work.  After
> removing the debug kernel, all is fine again.
> 
> My system is a 33 mhz 486 with 16 megs of ram and an ESDI drive.
> 

I too recently installed the debug kernel.  I also installed the PM debug 
DLLs at the same time.  I did not, however, experience the crashes that 
you have.  I also have a 486/33 with 16 Mb.  I do know that erratic 
behaviour can be expected if thePM debug DLLs are installed without the 
debug kernel.  Perhaps the converse is also true although I don't have a 
good explanation as to why that would be the case...

Barry King              bking@ersys.edmonton.ab.ca
Edmonton Remote Systems:  Celebrating 10 years of service to Northern Alberta

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads