Thread View: comp.os.os2.programmer
2 messages
2 total messages
Started by Robert Cain
Sun, 12 Apr 1992 23:17
com.sys and vcom.sys parameters?
Author: Robert Cain
Date: Sun, 12 Apr 1992 23:17
Date: Sun, 12 Apr 1992 23:17
7 lines
598 bytes
598 bytes
How do you tell com.sys and vcom.sys that there is a com3 on irq7 at
address 3e8?
--
Bob Cain rcain@netcom.com 408-358-2007
"There are some strings. They're just not attached."
Victoria Roberts
Re: com.sys and vcom.sys parameters?
Author: Michael D Kretzer
Date: Mon, 13 Apr 1992 02:24
Date: Mon, 13 Apr 1992 02:24
10 lines
969 bytes
969 bytes
From article <xfwjq4f.rcain@netcom.com>, by rcain@netcom.com (Robert Cain): > How do you tell com.sys and vcom.sys that there is a com3 on irq7 at > address 3e8? Add the following to the COM driver lines in your CONFIG.SYS. IRQ 7 might cause problems because OS/2 uses IRQ 7 for the LPT1 port (be sure not to use COM3 when printing, or vice-versa): DEVICE=C:\OS2\COM.SYS (3,3E8,7) DEVICE=C:\OS2\MDOS\VCOM.SYS (3,3E8,7)
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads