🚀 go-pugleaf

If you know what the NE2000 port/IRQ are, then add

basedev=reserve.sys /P:port,32 /IRQ:??

to the config.sys

then reboot, Alt-F1 at the white blob, and select Enable Hardware Detection..

this 'MAY' force the SB to be configured at some other address than
it was during install, so if the SB driver fails to load, then
rmview /dc >somefile from the commandline after boot,
figure out where the SB was configured and chage the
parms to the SB driver in config.sys

Warp 4 PnP configurator author..

(the NE2000 SHOULD have been detected by the DETNE2.SNP during install,
but we have seem some that go undetected for some reason..)


idiotxxx@mindless.com wrote:

> I have a problem with a SoundBlaster 16 Plug & Pray.
>
> I am unable to use it on my OS2 Warp 4 system.  I have an ethernet
> adaptor (NE2000 clone) which has software programmable IRQ etc and
> when my system boots up, as soon as the network drivers search for the
> card I get a trap as below.
> =======
> 07-27-1997  15:30:00  SYS3175  PID 0001  TID 0006  Slot 0006
> sysinit
> =======
>
> I am using an old 8bit card with jumpers that let me set the IRQ etc but I'd
> love
> to be able to use my 16 bit card.
> If I take eitehr the network card or the SB16 card out of the machine the
> other
> will work correctly.
>
> Has anyone else overcome this problem ?
>
> Specific system info can be provided if required.
>
> Any suggestions ??
>
> Nev..
>
>                *** anti-spam email address ***
>  *** remove the "xxx" from reply-to address before replying ***



--
Sam Detweiler
OS/2 Device Driver Development
OS/2 Advisor
IBM