Warp Connect install problem; pls help

Thread View: comp.os.os2.setup.misc

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Keith Bennett Wed, 17 Jan 1996 00:00

#223

Author: Keith Bennett
Date: Wed, 17 Jan 1996 00:00

26 lines
1608 bytes

I'm having a helluva time trying to install Warp on a Dell Pentium.  It 
was running fine before, but a power failure occurred and tahe disk got 
trashed.  I try to install Warp Connect, everything's fine up until the 
first reboot.

It starts up a little, loads a few device drivers, and then displays the 
message:

OS/2 is unable to operate your hard disk or diskette drive.  Correct the 
preceding error and restart the system.

This happens even when doing the Alt-F1, C bare boot.  I tried creating 
partitions on different parts of the physical drive, using FAT and HPFS, 
but always get the same error.

It is an all-IDE (unfortuantely) system with an IDE CD-ROM.  Are there 
newer drivers I must use than the ones on the Warp Connect install disks?

Thanks for any help on this.
- Keith

-- 
--------------------------------------------------------------------------
Keith Bennett                             Bennett Business Solutions, Inc.
Silver Spring, MD USA                     OS/2 & DOS Software Development
kbennett@cpcug.org                        (301) 871-7696

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads