🚀 go-pugleaf

In article <42vvo2$k1o@usenet4.interramp.com> mike_freeman@interramp.com (Mike Freeman) writes:
>I'm having a heckuva time getting an ASUS SC-200 to work with OS/2
>Warp.
>
>I"ve got it attached to a DAT drive, everything (the only 2 things on
>the SCSI bus - the controller and the drive) is terminated properly,
>and I've set up the CMOS to set INTA to IRQ 11. (I do have a PCI/IDE
>controller on INTD at IRQ 14 - not sure if that makes a difference). 

Try IRQ 9 if it is open. Keep the jumper on INTA on the SC-200. You didn't
mention your motherboard but on the plato you change the IRQ for the board
in the bios. Not sure about plug and play. I once heard that pci/ide would
interfer with the sc-200, but that was with a harddisk. I don't have a
pci/ide drive so I can't confirm this. I using my memory now :-), I think
you have to have a secondary controller for the scsi, but this is with a
harddisk don't really know about tape drives.

I have never had a problem with the sc-200 + plato motherboard using OS/2,
but I have no ide devices.

You need to post which dat drive, what motherboard, and other additional
information. That may help out.

Hope this helps,

Helen