🚀 go-pugleaf

"Ronald Gonzalez" <rggonzalez@asociacioncibao.com.do> wrote in message news:<HvOcnZwiKelG7NejXTWc3A@codetel.net.do>...
> Hello there.
> I am having problems when enabling a PCMCI ethernet card in a Thinkpad
> Iseries 1400 (type 2621-420) running under OS/2 Warp 4.5.
> The enabler from OS/2 says that the card doesnt exist, but if I run it this
> from a Dos sesion  the card is detected by  the enabler.
> 
> ---config.sys ---
> ....
> ....
> ....
> BASEDEV=PCMCIA.SYS
> DEVICE=C:\THINKPAD\VPCMCIA.SYS
> DEVICE=C:\THINKPAD\PCMSSDIF.SYS
> DEVICE=C:\THINKPAD\PCM2SRAM.SYS
> DEVICE=C:\THINKPAD\FLSH2MTD.SYS
> DEVICE=C:\THINKPAD\PCM2FLSH.SYS
> BASEDEV=PCM2ATA.ADD /S:2 /!DM /NOBEEP
> DEVICE=C:\OS2\BOOT\COM.SYS
> DEVICE=C:\OS2\MDOS\VCOM.SYS
> BASEDEV=OS2PCARD.DMD
> BASEDEV=AUTODRV2.SYS c:\os2\autodrv2.ini
> DEVICE=C:\IBMCOM\MACS\ECARD.OS2 /irq=3 /io=360       <=THIS IS THE
> ENABLER....
> DEVICE=C:\IBMCOM\MACS\PCMND.OS2                            <=THE ETHERNET
> DRIVER
> DEVICE=C:\THINKPAD\$ICPMOS2.SYS /G
> BASEDEV=IBM2SS04.SYS
> ....
> --------------------
> 
> Once I could configure and worked but after restarting didnt anymore!
> Any sugestion ?

I remember that some PCMIA ethernet cards use a point type driver
which enables the card independent of the general OS/2 PCMCIA drivers.
 You may try disabling the general OS/2 enabler for the particular
slot you are placing the card in.  It may also be necessary to reserve
the IRQ / IO resources required by the card at the beginning of config
sys.  But I'd try step one first, and see how you go.

Good luck.