🚀 go-pugleaf

In <823439164.2504@intra.demon.co.uk> paul@intra.demon.co.uk (Paul)
writes: 
>
>Please help, I was up 'til 2am this morning trying to configure the HP
>600C.
>>First problem: Could not install the 3 disks of software.
Installation
>crashed each time at 52% on disk 2, which meant the drivers were not
>loaded correctly. The error message was "the module sconfig.dll is in
>use, exit and restart windows and re-run set up".
>During the day I re ran set up about 15 times. We closed all
>applications and turned off the screen saver and network  but all to
no
>avail.

I had this problem also but on running setup several times it finaly
loaded. In addition when the software tested the printer it said it had
"trouble communicating with the printer.". Later I found out that the
printer cable that I had been using with several other printers would
not work with the 600C, it required a cable buildt to some new
standard. one of the indicators of this was in dos control pannel it
would say "Color cartridge not found" or something to that effect.

Hope this helps.

Gary