🚀 go-pugleaf

Hello,

I have just purchased the Adara ImageStar 1. Here is my problem. I hope
you can assist me.

scanner model: IMAGESTAR 1
computer type: Power Computing Power Center 150, 80 mb RAM
OS version:		MAC 0S8
a brief description of the problem:

Plug In will not recognize the scanner. (" Can't find scanner"). I have
the plug-in installed in Adobe Photoshop 3.0. (Should I install in "Color
It" instead?)

 The SCSI chain is as follows:

Iomega Drive is #5, Scanner is #6. I have changed the scsi number on both
peripherals, using the terminator on the scanner as it is last in the
scsi chainr. I have set termination to the "off" position on the Iomega
Drive. I have the latest software, Adara Scan V3.0.7A an have just
downloaded "R2" from Adara website.

The scsi chain recognized still says the Iomega Drive is #6, even though
I have physically changed the number. There is no scanner in the chain,
as recognized by the Adara s/w

I have noticed that scanner does not do a "self-test" as described in the
manual. Should this happen each time the scanner is turned on?

Also, when turing the scanner on, there is a "rumbling sound" for a few
seconds. This sound is generated by the long piece in the front of the
scanner. Normal? The green light flashed several times, then remains on
along with the power light.

Thank you for your prompt reply.

Sincerely,

Chuck Silverman
TEL 818 609 1629 (Reseda, CA)

-------------------==== Posted via Deja News ====-----------------------
      http://www.dejanews.com/     Search, Read, Post to Usenet