🚀 go-pugleaf

In <825214602snz@longley.demon.co.uk> David Longley
<David@longley.demon.co.uk> writes: 
>
>I have an internal V34 half slot modem which is reporting "No Dial
Tone" when
>I try dialing out. It only allows X1, X2 X3 and X4, and only X2 and X4
sense
>dial tone. When set to X1 and X3 it tone dials OK, but there is no
dialtone.
>
>I've checked the cable by plugging a phone into the socket on the
modem marked 
>PHONE and I can hear the line pulsed as the modem starts to dial but
that's
>all. I've run internal diagnostics on the modem and the terminal <-->
modem
>checks out fine. I get an OK from ATZ and there's no problem doing an
AT&F.
>I've tried it in several diferent slots too.
>
>I've tried cleaning the pins inside the socket......anyone got any
suggstions
>where to look next?
>-- 
>David Longley
heppened to me just today. I had the wall jack plugged in where the
phone should go. I switched it and it was ok. Not much chance this is
your problem 'tho, is it?
bob